عرض مشاركة واحدة
قديم 01-05-2012, 06:17 PM   #4
فريكر
:: سيسكو مميز ::
 
الصورة الرمزية فريكر
 
تاريخ التسجيل: Jan 2011
المشاركات: 366
شكراً: 11
تم شكره 99 مرة في 42 مشاركة
فريكر will become famous soon enough
إرسال رسالة عبر مراسل MSN إلى فريكر
افتراضي رد: لابات حلها تضمن شهادة ccna

حل المجموعة الاولى Basic Networking
NA-1-1-BasicConfig.pka
NA-1-2-IPv4addressing.pka
NA-1-3-IPv6addressing.pka

كود:
<<Answer for LAB 1-1: Basic Configuration>>

[On Ranet A (via console)] :
(Go to Desktop Tab > Terminal)
Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#hostname RanetA
RanetA(config)#enable secret ranetenablepass
RanetA(config)#line con 0
RanetA(config-line)#password ranetconsolepass
RanetA(config-line)#login
RanetA(config-line)#line vty 0 4
RanetA(config-line)#password ranettelnetpass
RanetA(config-line)#login
RanetA(config-line)#int fa0/0
RanetA(config-if)#no sh

%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
RanetA(config-if)#ip add 10.0.0.1 255.255.255.252
RanetA(config-if)#int fa0/1
RanetA(config-if)#no sh

%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up
RanetA(config-if)#ip add 192.168.0.254 255.255.255.192
RanetA(config-if)#
RanetA#
%SYS-5-CONFIG_I: Configured from console by console
RanetA#copy run start
Destination filename [startup-config]?
Building configuration...
[OK]
RanetA#ping 10.0.0.2

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.0.0.2, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 2/3/5 ms

RanetA#

[On Ranet PC] :
(Go to Desktop Tab > Command Prompt)
Packet Tracer PC Command Line 1.0
PC>telnet 192.168.0.254
Trying 192.168.0.254 ...Open


User Access Verification

Password: ranettelnetpass
RanetA>
كود:
<<Answer for LAB 1-2: IPv4addressing>>

[On Ranet BR (via console)] :
(Go to Desktop Tab > Terminal)
Ranet-BR>en
Ranet-BR#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Ranet-BR(config)#int s0/0/0
Ranet-BR(config-if)#no sh

%LINK-5-CHANGED: Interface Serial0/0/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed  state to upRanet-BR(config-if)#ip add 192.168.0.253 255.255.255.252
Ranet-BR(config-if)#int s0/1/0
Ranet-BR(config-if)#no sh

%LINK-5-CHANGED: Interface Serial0/1/0, changed state to up

%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1/0, changed  state to up Ranet-BR(config-if)#ip add 192.168.0.29 255.255.255.252
Ranet-BR(config-if)#int fa0/0    
Ranet-BR(config-if)#no sh

%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Ranet-BR(config-if)#ip add 192.168.0.14 255.255.255.240
Ranet-BR(config-if)#int fa0/1
Ranet-BR(config-if)#no sh

%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed  state to up Ranet-BR(config-if)#ip add 192.168.0.22 255.255.255.248
Ranet-BR(config-if)#

%SYS-5-CONFIG_I: Configured from console by consoleRanet-BR#
Ranet-BR#copy run start
Destination filename [startup-config]? 
Building configuration...
[OK]
Ranet-BR#ping 192.168.0.254

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.0.254, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/5/6 ms

Ranet-BR#ping 192.168.0.30

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.0.30, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 3/3/5 ms

Ranet-BR#

[On Host1 in LAN1] :
(Go to Desktop Tab > IP Configuration)
IP Address: 192.168.0.1
Subnet Mask: 255.255.255.240
Default Gateway: 192.168.0.14
(Go to  Desktop Tab > Command Prompt)
Packet Tracer PC Command Line 1.0
PC>ping 192.168.0.33

Pinging 192.168.0.33 with 32 bytes of data:

Reply from 192.168.0.33: bytes=32 time=12ms TTL=254
Reply from 192.168.0.33: bytes=32 time=13ms TTL=254
Reply from 192.168.0.33: bytes=32 time=7ms TTL=254
Reply from 192.168.0.33: bytes=32 time=9ms TTL=254

Ping statistics for 192.168.0.33:
    Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
    Minimum = 7ms, Maximum = 13ms, Average = 10ms

PC>

[On Host1 in LAN2] :
(Go to Desktop Tab > IP Configuration)
IP Address: 192.168.0.17
Subnet Mask: 255.255.255.248
Default Gateway: 192.168.0.22
(Go to  Desktop Tab > Command Prompt)
Packet Tracer PC Command Line 1.0
PC>ping 192.168.0.33

Pinging 192.168.0.33 with 32 bytes of data:

Reply from 192.168.0.33: bytes=32 time=16ms TTL=254
Reply from 192.168.0.33: bytes=32 time=8ms TTL=254
Reply from 192.168.0.33: bytes=32 time=11ms TTL=254
Reply from 192.168.0.33: bytes=32 time=7ms TTL=254

Ping statistics for 192.168.0.33:
    Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
    Minimum = 7ms, Maximum = 16ms, Average = 10ms

PC>
كود:
<<Answer for LAB 1-3: IPv6addressing>>

[On Ranet HQ (via console)] :
(Go to Desktop Tab > Terminal)
Ranet-HQ>en
Ranet-HQ#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Ranet-HQ(config)#ipv6 unicast-routing 
Ranet-HQ(config)#int s0/0/0
Ranet-HQ(config-if)#ipv6 add FEC0:78:0:1::2/64
Ranet-HQ(config-if)#no sh

%LINK-5-CHANGED: Interface Serial0/0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed state to up
Ranet-HQ(config-if)#int s0/1/0
Ranet-HQ(config-if)#no sh

%LINK-5-CHANGED: Interface Serial0/1/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1/0, changed state to up
Ranet-HQ(config-if)#ipv6 add 2001:21::2/48
Ranet-HQ(config-if)#int fa0/0
Ranet-HQ(config-if)#no sh

%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Ranet-HQ(config-if)#ipv6 add FEC0:78:0:2::/64 eui-64 
Ranet-HQ(config-if)#ipv6 add 2001:22::/48 eui-64 
Ranet-HQ(config-if)#

%SYS-5-CONFIG_I: Configured from console by consoleRanet-HQ#
Ranet-HQ#copy run start
Destination filename [startup-config]? 
Building configuration...
[OK]
Ranet-HQ#

[On Host1 (local)] :
(Go to Desktop Tab > Command Prompt)
Packet Tracer PC Command Line 1.0
PC>ping FEC0:78:0:1::1

Pinging FEC0:78:0:1::1 with 32 bytes of data:

Reply from FEC0:78:0:1::1: bytes=32 time=29ms TTL=254
Reply from FEC0:78:0:1::1: bytes=32 time=11ms TTL=254
Reply from FEC0:78:0:1::1: bytes=32 time=13ms TTL=254
Reply from FEC0:78:0:1::1: bytes=32 time=11ms TTL=254

Ping statistics for FEC0:78:0:1::1:
    Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
    Minimum = 11ms, Maximum = 29ms, Average = 16ms

PC>

[On Host2 (global)] :
(Go to Desktop Tab > Command Prompt)
Packet Tracer PC Command Line 1.0
PC>ping 2001:21::1

Pinging 2001:21::1 with 32 bytes of data:

Reply from 2001:21::1: bytes=32 time=21ms TTL=254
Reply from 2001:21::1: bytes=32 time=13ms TTL=254
Reply from 2001:21::1: bytes=32 time=9ms TTL=254
Reply from 2001:21::1: bytes=32 time=13ms TTL=254

Ping statistics for 2001:21::1:
    Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
    Minimum = 9ms, Maximum = 21ms, Average = 14ms

PC>
فريكر غير متواجد حالياً   رد مع اقتباس
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37